Adding Storage to a FOG Server

From FOGProject Wiki
Jump to: navigation, search
It has been suggested that this article or section be merged with Moving your images directory/Adding Storage to the Images directory. (Discuss)


Contents

Overview

This tutorial will cover how to add an additional hard disk to a server and mount it as /images. For example if you installed the host operating system on a drive that was 80GB, now you wish to add a new 1TB hard disk to mount as /images keeping the rest of the OS on the 80GB disk.

In this tutorial we are assuming you are using Ubuntu and that the disk you are installing is not formatted. If the drive is formatted, it may mount automatically, if you does, right click on it and select dismount.

Preparing new disk

  • Connect the new drive to the host system.
  • Determine device name by typing
sudo fdisk -l

It should look something like /dev/sdb (without a number after it), we will refer to this as [yourdevice].

Make sure this is correct because we will be destroying everything on this device, so make sure the disk capacity matches, etc.

  • Lets wipe out the MBR and then some, type
sudo dd if=/dev/zero of=[yourdevice] count=20 bs=512

Partitioning

  • Now lets partition it
sudo fdisk [yourdevice]
n
p
1
1
[press enter]
t
83
a
1
w

Formating and Mounting

  • Put a filesystem on it
sudo mkfs.ext3 [yourdevice]1 (add a 1 to the end of your device name!)
  • Your device is setup! Lets move your old images directory.
sudo mv /images /images.old
  • Create the new mountpoint
sudo mkdir /images
  • Now lets mount your new driver as /images
sudo mount -t ext3 /dev/sdb1 /images
  • Make sure the new driver is mounted
mount

You are looking for [yourdevice] on /images

  • Copy your old images and data to the new device
sudo cp -av /images.old/* /images/
  • Create the .mntcheck file in the new images folder
sudo touch /images/.mntcheck
  • Now make sure your new device gets mounted at system startup
sudo gedit /etc/fstab
  • Add the following line:
 [yourdevice]1	/images 	ext3   defaults   0   0

[yourdevice] should have the number 1 at the end of it.

  • Change permissions on the device
sudo chmod 777 -R /images
  • Now restart and make sure the new image volume mounts.
Personal tools
FAQs / Troubleshooting